CONFIGURABLE TESTING FOR CHASSIS COMPONENT


Specifications

  • Max Force            : ± 50 KN(2Nos.), ±25 KN(2 Nos)


  • Max Stroke          : ±125 mm


  • Max Frequency     : 15 Hz (15Hz response at +/-5mm
                                amplitude Is considered as
                                representative)


  • Controller            : National Instrument Compact
                                RIO With FPGA Backplane.


  • Control Software   : Labview 8.6
                                (Upgrades will be provided during
                                the warranty)
                                (National Instruments).


  • Control Front End : (IPC) P4 Intel at 2.5 GHz,512MB,                              80GB, 2xUSB, CD RD/WR, 17”                              TFT LCD.


  • Force Sensor       : ±50 KN (2 Nos.) & ±25 KN (2 Nos.)
                               Fatigue Resistant. (HBM)


  • Position Sensor   : Linear Potentiometer. (GEFRAN)


  • Servo Solenoid    : 100 LPM , 60 Hz response.


  • Pressure Sensor  : 250 Bar (11 Nos.)
  • To establish in house facility to test products such as Frame Suspensions, Cross members, Arms etc.

  • To carry out Load Fatigue, Static Strength test, Vibration Durability Test and Cyclic Fatigue tests on the above jobs.

  • To configure a test with programmable Load Amplitude, frequency and no. of Cycles.

Note: 15 Hz response at ±5mm is considered to be representative for all the hydraulics calculations.

          Response above 5 Hz is available for strokes less than ±5 mm.